20mm through axle, built with tapering blades. This is actually something I've never done before, but I think it came out looking pretty neat. Note that the ugly-ass bolts in the binders are the ones I use when welding/brazing, they will be replaced with nice pretty ones before the fork goes out.
I'm sort of working on two frames at once right now, which is usually something I try to avoid, just because I'm easily confused. Going to work on finishing up John's FS bike (pictures to come) today and tomorrow while I wait for some parts for Arne, then move on to that project.
20mm through axle, built with tapering blades. This is actually something I've never done before, but I think it came out looking pretty neat. Note that the ugly-ass bolts in the binders are the ones I use when welding/brazing, they will be replaced with nice pretty ones before the fork goes out. 
I'm sort of working on two frames at once right now, which is usually something I try to avoid, just because I'm easily confused. Going to work on finishing up John's FS bike (pictures to come) today and tomorrow while I wait for some parts for Arne, then move on to that project.
4 comments:
It must be cold in CO... your floor looks cleaner than normal.
Could you comment a bit on tapered blades? I did a search for older blog posts but didn't find anything. Thanks
Could you comment a bit on tapered blades? I did a search for older blog posts but didn't find anything. Thanks
Have you done a Maxel fork setup?
Post a Comment